Raymond mill equipment production affected by the material being dried causes and solutions2019-08-19 16:18:25

Project Background

After long-term operation of Raymond Mill equipment, improper handling of various problems in the equipment during use will affect the output of the equipment. Similarly, after long-term use

Raymond mill equipment production affected by the material being dried causes and solutions

After long-term operation of Raymond Mill equipment, improper handling of various problems in the equipment during use will affect the output of the equipment. Similarly, after long-term use, Raymond mill may also experience reduced production. There are many main reasons that affect the production of equipment. When many users are looking for a reduction in output, they are generally considered to be the cause of the decline in production due to the equipment itself. In addition to the reasons existing on the equipment, it may be due to the material issues of the material itself. . Then again, when it comes to how to solve the problem of openness, it needs to be considered in various ways. It is not enough to pay attention to only one point. There are many kinds of internal and external factors in the production process. It is necessary to analyze according to specific conditions and pay attention to the cause of the investigation. Solve the problem. The following is a summary of SBM Heavy Industry's summary of the reasons for the impact of the material production decline and the related processing methods to reduce the output. Those who need it can read it in detail.

Raymond Mill

1, the material hardness. The hardness of the processed material is too large, the efficiency of the grinder is lower, and the yield is also reduced. Solution: The hardness of the material can be detected, whether the hardness of the selected material is too large, or materials that are not suitable for this type of equipment are selected.

2, the material particles are too large. The processing time of materials with large granularity is relatively long, and the greater the degree of wear on the equipment, the lower the service life of the equipment and the final output. Solution: Consult the relevant technical personnel to check the particle size of the material and check the equipment for severe wear. Jaw crushers can be used to crush material, increase crushing strength, and increase material fineness. This reduces grinding time and equipment losses.

3, too much fine powder in the material. Too much powder will directly affect the output of the equipment. Solution: The material can be sifted and sieved out of too much powder. If it is ground through the equipment, the output will be greater.

4, material humidity is too large. The materials with high humidity are easy to adhere to the equipment, causing the equipment to be clogged, affecting the operation of the equipment and bottoming out the output. Solution: The moisture content of the material is controlled within 10%. It can also increase the drying of the material by the dryer. The efficiency of the powder after drying is higher, and the equipment is not obstructed and the output is relatively higher.

5, the material viscosity is too high. The lower the milling rate of a high-viscosity material, the higher the milling rate of a low-viscosity material, and the less viscous material can be selected for processing.

The volume of operations of Raymond Mill's equipment is relatively large. When users encounter problems related to the reduction of production, they lack the understanding of the processed materials. It is easy to overlook the influence of equipment on the output of the equipment. For different materials, the operation of the equipment is different. The texture, structure and physical properties of materials need to be known, so that a reasonable production process standard can be established in production so that the causes can be discovered early and the solutions to the related questions can be grasped so that they can be used in production. The biggest advantage of the equipment is to increase the output of the equipment.

Too tired to read? Try staff service!

Engineer one-to-one for you, draw up plans in time, and provide investment estimates in time!

Staff ServiceGet Price

Submit Demands Online

Hot Sale